Monday, March 5, 2012

StempleLABS Stingray robot - part 1 - Introduction

This Stingray robot chassis and drive system is a Parallax kit that I purchased at the Propeller Expo 2011. It came with the now discontinue Propeller Robot Control board.  This included regulated power, motor speed controller and other peripherals.  The kit was built right away and I tested with various demo programs, but the it sat on the shelf with my other bots (all in various stages of form and function).

A couple weeks later I added the PING))) kit for Stringray (3 front facing pings) and again run demo programs and minor coding.  It was hungry for AA batteries so I didn't get very far...



No comments:

Post a Comment